73
Chapter 4 Advanced Usage
Software Setting Mode
Set the printer's memory switches and customized values.
See "Software Settings" on page 58 for information about available functions and settings and how to set them.
F
ollow the steps below.
1
After running a self test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the power LED flashes.
2
Briefly press the Feed button three times (less than one second), and then hold it
down for at least one second to enter the Software settings mode (Customized value
setting).
The Software setting mode guidance is printed, and the power LED flashes.
3
After briefly pressing the Feed button (less than one second) for the number of times
shown in the print result, hold down the button for more than one second to select
the setting items.
The setting selected as the setting item, the current settings and initial settings are printed.
Depending on the setting item, you may need to continue selecting the setting item before the
settings are printed.
For details on setting items, see "Software Settings" on page 58.
You can also make the software settings using the ESC/POS commands.
To Next Page
Loading...
Need help?
General
