For SC-F3080
Product name Product number Explanation
Waste Ink Bottle C13S210072 Identical to the waste ink bottle supplied with the printer.
Head Cleaning Set C13S210106 Set of flushing pads and wiper unit.
Anti-Drying Cap C13S210110 Replacement anti-drying caps.
Air filter C13S210112 Replacement air filters.
Flushing Pad Set C13S210108 Purchase when changing only the flushing pads.
Maintenance Kit T7362 The same as the maintenance kit supplied with the printer.
Cleaning ink supply unit T44AC Use for Keeping Preparation and to change the Printer
Mode.
Clean Room Wiper
*
C13S090016 The same as the clean-room wipers supplied with the
printer.
* Not available for purchase in some countries and regions. We recommend BEMCOT M-3II by Asahi Kasei Corporation when
purchasing commercial products.
Others
Except for SC-F3080
Product Part number Explanation
Pre-treatment Liquid T43R1
T7361
20 liters. Dilute before use.
U “Pre-treatment” on page 39
Polyester Pre-treatment Liquid T43R2 18 liters. Use undiluted or diluted depending on the ink
used for printing.
U “Pre-treatment” on page 39
Hanger Platen - L C12C936241 Printable area: 16" x 20"/406 x 508 mm
Hanger Platen - M C12C936261 Printable area: 14" x 16"/356 x 406 mm
Hanger Platen - S C12C936281 Printable area: 10" x 12"/254 x 305 mm
Extra Small Platen C12C933951 Printable area: 7" x 8"/178 x 203 mm
Sleeve Platen C12C933971 This platen allows you to print on T-shirt cuffs.
Printable area: 4" x 4"/102 x 102 mm
Medium Grooved Platen C12C933961 This platen allows you to print correctly on polo shirts as
well as shirts with zippers and buttons.
Printable area: Equivalent to the area for M size hanger
platen
Platen Grip Pad - L C13S210118 A grip pad for using the L-size hanger platen as a grip pad
covered platen.
Platen Grip Pad - M C13S210119 A grip pad for using the M-size hanger platen as a grip pad
covered platen.
SC-F3000 Series User's Guide
Appendix
135
To Next Page
Loading...
Need help?
General