Making Wi-Fi Settings from the Control Panel (WPS)
You can connect to Wi-Fi from the printer's control panel using the WPS function.
Related Information
& “Making Wi-Fi Settings by Push Button Setup (WPS)” on page 55
& “Making Wi-Fi Settings by PIN Code Setup (WPS)” on page 56
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏
e
access point is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the access point.
1. Tap on the home screen.
2. Select Router.
3. Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change to Wi-Fi
connection. or Change Settings to change the settings.
4. Select Push Button Setup(WPS).
5. Hold down the [WPS] button on the access point until the security light ashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
6. Tap Start Setup.
Administrator's Guide
Appendix
55
To Next Page
Loading...
Need help?
General