To Next Page

To Previous Page

Changing the Wi-Fi Direct (Simple AP) Settings

When Wi-Fi Direct (simple AP) connection is enabled, you can change the settings from > Wi - F i D i re c t

> Start Setup > Change Settings, and then the following menu items are displayed.

Change Network Name

Change the Wi-Fi Direct (simple AP) network name (SSID) used for connecting to the printer to your arbitrary

name. You can set the network name (SSID) in ASCII characters that is displayed on the soware keyboard on the

control panel.

When changing the network name (SSID), all connected devices are disconnected. Use the new network name

(SSID) if you want to re-connect the device.

Change Password

Change the Wi-Fi Direct (simple AP) password for connecting to the printer to your arbitrary value. You can set

the password in ASCII characters that is displayed on the soware keyboard on the control panel.

When changing the password, all connected devices are disconnected. Use the new password if you want to re-

connect the device.

Changing frequency range

Change the frequency range of Wi-Fi Direct used for connecting to the printer. You can select 2.4 GHz or 5 GHz.

When changing the frequency range, all connected devices are disconnected. Re-connect the device.

Note that you cannot re-connect from devices that do not support 5 GHz frequency range when changing to 5

GHz.

Depending on the region, this setting may not be displayed.

Disable Wi-Fi Direct

Disable Wi-Fi Direct (simple AP) settings of the printer. When disabling it, all devices connected to the printer in

Wi-Fi Direct (Simple AP) connection are disconnected.

Restore Default Settings

Restore all Wi-Fi Direct (simple AP) settings to their defaults.

e Wi-Fi Direct (simple AP) connection information of the smart device saved to the printer is deleted.

Note:

You can also set up from the Network tab > Wi- Fi D ir e c t on Web Cong for the following settings.

❏ Enabling or disabling Wi-Fi Direct (simple AP)

❏ Changing network name (SSID)

❏ Changing password

❏ Changing the frequency range

❏ Restoring the Wi-Fi Direct (simple AP) settings

Changing the Connection Method

Change the connection method. Make this setting on the network enabling condition.

Administrator's Guide

Appendix

Epson SureColor SC-P5300 User Manual

Questions and Answers: