Appendix A-4 General Specifications Rev.B
Confidential
Autocutter
Either of the following settings can be applied.
Note:
❏
Once the printer is used, do not change the cutting method from partial cut to full cut, since the wear
rate on the blades differs between the areas where the paper passes and where the paper does not, which
can result in a paper-cutting problem. However, if the printer is new, you can change the cutting
method from partial cut to full cut.
❏
If the printer is installed horizontally and the full cut is chosen, attach the paper outlet guide. (Refer to
Chapter 6.) If it is not attached, the cut paper falls inside the paper path, which can result in double-
cutting, a paper jam, or cutter error.
Table A-1 Autocutter settings
Setting Description
Partial cut (cutting with one point in left
edge left uncut)
Set by changing the autocutter
unit position.
Full cut (completely cut)
To Next Page
Loading...
Need help?
General
