Rev.B Installation 6-1
TM-L90 Service Manual
Confidential
Chapter 6
Installation
Installation Precautions
CAUTION:
❏
Do not place the printer in an unstable place (such as on an unsteady base or on a
slanted surface). The unit may fall or drop, and may cause injury.
❏
Do not place the printer in a location where it is exposed to excessive humidity or
dust. It may malfunction or cause fire.
❏
Do not wire cables other than as instructed in this document. Improper wiring may
cause malfunction or fire.
Installation Position
This printer can be installed vertically, horizontally, or mounted on the wall. If you change the
installation position, you also need to set the installation position of the roll paper near-end
detector. (Refer to the section, "Setting the Installation Position of the Roll Paper Near-End
Detector," in this chapter.)
Vertical Installation
Place the printer with the paper exit facing forward.
To Next Page
Loading...
Need help?
General
