E045 31 732786 - Rev.C
ENGLISH
6.4 DELETING THE RADIO CONTROLS
This operation CANNOT be reversed. This will delete ALL the radio control codes me-
morised as both OPEN A and OPEN B/CLOSE. The cancellation procedure is active only
in gate status visualisation mode.
1. Press and hold -/R2
-/
R2
.
• After pressing for about 5 sec, the DL12 LED begins to flash slowly; after another 5 sec of slow
flashing and holding, the LEDs DL11 and DL12 begin flashing more rapidly (cancellation has started).
• Once rapid flashing has stopped, LEDs DL11 and DL12 will go on steady, confirming the cancellation
of all the radio codes (OPEN A and OPEN B/CLOSE) from the board memory.
2. Release -/R2
-
/
R2
. The LEDs will go off, indicating correct cancellation.
To Next Page
Loading...
Need help?
General
