7.8.3 RangePoint RTX
Set correction signal
1.
Select the correction signal via the "Signal
Type" selection field.
2.
Set the frequency.
3.
Select the service ID.
4.
Select the baud rate.
Fig. 50
Display
Satellite receiver Designation of the installed receiver
Frequency
Baud rate
Accuracy Bar indicator and decimal value of static accuracy
Signal lag Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Connection status Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Authorisation level Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
Serial no. Trimble AG-382 serial number (6-digit)
Expiry date Expiration date for RangePoint RTX license
7. Start-up
102 VarioGuide
438.020.070.012
To Next Page
Loading...
Need help?
General