Display
Distance to Base Distance in m
Network ID
Signal format The signal format is displayed
7.10.2 RTK network (internal GSM/GPRS modem)
7.10.2.1 Configure the internal mobile modem correction signal (GSM/GPRS)
NOTE:
After the ignition has been switched OFF/ON, the system connects to the GSM/GPRS network
automatically and without further notice, provided that a connection was established before the ignition
was switched off. Please note that this action may result in data charges.
Set correction signal
1.
Select the correction signal via the "Signal
Type" selection field.
2.
Select 'Internal Modem' as the modem type
3.
Select either 'GSM' or 'GPRS' as the
connection type
Fig. 55
Display
Satellite receiver Designation of the installed receiver
Signal type The correction signal source can be selected here
Modem type Internal modem
Connection type Dial connection (GSM) / Data connection GPRS
Signal strength Mobile communications signal strength
Accuracy Bar indicator and decimal value of static accuracy
7. Start-up
VarioGuide 107
438.020.070.012
To Next Page
Loading...
Need help?
General