To Next Page

To Previous Page

7.7.2 External station

7.7.2.1 Configure the external station correction signal

Procedure

Select the correction signal via the "Signal

Type" selection field.

NOTE:

Correction signal activation can only be

received if a green tick appears in the

connection status. Where applicable, verify

channel, frequency and signal format.

Select 'External Station' under station type

Configure baud rate

Select parity

Select signal format

Fig. 43

Display

Satellite receiver Designation of the installed receiver

Signal type The correction signal source can be selected here

Base Type External station

Accuracy Bar indicator and decimal value of static accuracy

Signal lag Specifies the time in s taken to receive the correction signal update. If 999 is

shown here, the correction signal cannot be currently received.

Connection status Specifies the connection status of the GNSS receiver to the source of the

correction data (e.g. connected, update required, expired). The tick shows

whether the GNSS receiver is currently connected to the correction data

source.

Authorisation level Specifies the accuracy level of the GNSS receiver (depending on the hardware

modules installed in the receiver)

Distance to Base Distance in m

7. Start-up

VarioGuide 95

438.020.070.012

FENDT varioguide User Manual

Questions and Answers: