FENDT varioguide User Manual

Fault Possible cause: Indication Remedy
more are displayed on
the flat.
No OmniSTAR correction
signal is present in the
operating region of the
tractor.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status, page 125.
Inform OmniSTAR of the
tractor's operating
region.
Poor reception of
OmniSTAR correction
signal.
Correction signal satellite
is not visible.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status, page 125.
<xref href="#T003398"/
>.
OmniSTAR has not sent
full data for correction
signal / license.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status,
page 125.
Contact your FENDT
dealer.
The correction signal has
been set incorrectly at
the terminal.
A red cross appears in
field (B) of System info,
see
chapter 7.13.1 Check
system info/system
status, page 125.
Set proper correction
signal.
Incorrect receiver serial
number transmitted to
OmniSTAR.
Send OmniSTAR correct
receiver serial number.
8. Faults and remedy
148 VarioGuide
438.020.070.012

FENDT varioguide Specifications

General

Brand	FENDT
Model	varioguide
Category	Tractor Accessories
Language	English