68
TIG welding
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
► Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
► Do not use the functions described here until you have fully read and understood all of
the Operating Instructions for the system components, in particular the safety rules!
WARNING!
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there is
a high risk of very serious injury and damage.
► Before carrying out any work on the device make sure that the power source mains
switch is in the "O" position
► Before carrying out any work on the device make sure that the power source is un-
plugged from the mains
Welding parame-
ters
Starting current I
S
Unit %
Setting range 0 - 200% of main current I
1
Factory setting 35 AC, 50 DC
The starting current I
S
is saved separately for the "TIG AC welding" and "TIG DC
welding" modes.
UpSlope t
up
Unit s
Setting range 0.0 - 9.9
Factory setting 0.5
The UpSlope t
up
is saved separately for 2-step and 4-step modes.
To Next Page
Loading...
Need help?
General
