FUJITSU DL3100
User’s Manual 6-1
CHAPTER 6CUSTOMIZED FORM
CUSTOMIZED FORM
This printer allows the customization on the form length, TOF,
bottom margin and left margin for single sheets and fanfold.
Selecting the Define value(s) in section 5.2 (Paper Setup menu)
allows the printer to take up the customized page formatting
The parameter setting procedures involve:
1.
The printer prompts the dialogs and you follow the prompts.
2.
Before every measurement or change, the print instructs you to
unload the conversation form from the printer.
3.
With the exception of measuring the form length for cut sheets,
always set the lever to the tractors position .
4.
For form length measurement, insert the customized form from
the proper paper path.
The other six settings are actually done on general fanfold forms ---
not the actual customized form. Fanfold paper gives direct visual
results on the TOF, bottom and left margins even though cut sheets
will be used in actual application.
This chapter describes the following operations:
- Customize Cut Sheet Form Length
- Customize Cut Sheet TOF
- Customize Cut Sheet Bottom Margin
- Customize Cut Sheet Left Margin
- Customize Fanfold Page Formatting Parameters
To Next Page
Loading...
Need help?
General
