FUJITSU DL3100
5-40 User’s Manual
BIDIRECTION
AL
ALIGNMENT
When wiggling vertical grids appears in tabular reports, you
should adjust the Bidirectional Alignment. The procedures to
adjust bi-directional alignment across adjacent line grids:
1. Hold down the [Tear off] key while powering on the printer
and then release the key when the print head starts to move.
After loading paper, the printer prompts the Printer Settings.
[LF]=Next, [TEAR]=Back, [LOAD/EJECT]=OK, [ONLINE]=Exit,
[ONLINE]+[LOAD/EJECT]=Save and restart the printer.
System Setup
2. Press the Next or Back keys to scroll forward or backward
the sub-menus till the printer shows:
3. Press [Load/Eject] to confirm the current settings. Due to
“Single paper text”, “Single paper graphy”and “Multiayer
paper” are controlled by different instructions, the printer will
print:
Bi-directional Alignment
Single paper text
The printer waits for instructions:
A If you need a "Single paper text" bidirection test and
longitudinal correction, press the [Load/Eject] button to
confirm the current setting.
B If you need a “Single paper graphy” bidirection test and
longitudinal correction,press [LF/FF] to select “Single paper
graphy” and then press [Load/Eject]to confirm.
C If you need a “Mutilayer paper” bidirection test and
longitudinal correction,press [LF/FF] to select “Mutilayer
paper” and then press [Load/Eject]to confirm.
D If you need a “Parity Check” bidirection test and ongitudinal
correction,press [LF/FF] to select “Parity Check” and then
press [Load/Eject]to confirm.
To Next Page
Loading...
Need help?
General
