Troubleshooting and tips
Error messages on the screen
Errormess agesonthe screenErrors
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are describ e d in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
Error mes sage/cause Troubleshootin g
System CMOS checksum bad - Default con figuration
used
The system configuration information is
incorrect.
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► Keep the vo lume button an
d the shortcut
button pressed and swit
ch the Tablet PC
on. If you keep the volu
me button pre ssed
during the boo t proce
ss, you can switch into
the BIOS Setup-
► In the BIOS Setup, select the Exit menu.
► Select th e entry Loa
dSetupDefaults.
► Select OK and press the Enter key.
nn Stuck key
► Make sure that no key is p ressed.
Operating system not found
► Check in the BIOS Setup whether your hard
disk has been set correctly.
► M ake sure that the ope rating system is
installed on the corresponding drive.
Press <F1> to re
sume,<F2>toSETUP
This error mes
sage appears if an error occurs
during th e sel
f-test before starting the operating
system.
► Press the
Alt
tablet button to boot the
operating system
Real time cl
ock error
► Contact your sales outlet or our customer
service center.
nnnnK Shadow RAM failed at offset: xxxx Failing
Bits: zzzz
► Contact your sales outlet or our customer
service center.
System battery is de ad - Replace and run SETUP
► Contact y
our sales outlet or our customer
service c
enter.
System c
ache error - Cache disabled
► Contact your sales outlet or our customer
service center.
System
timer error
► Contact your sales outlet or our customer
service center.
Fujitsu 75