Furuno FAR-2117 Service Manual

7.3 Processor Unit: RPU-013
7-27
7.3 Processor Unit (RPU-013)
7.3.1 Overview
Processor unit is comprised of SPU, NET-100, PWR, TX-HV, TB and FIL boards. This
unit is used commonly to X-band and S-band radars and different outputs. However, the
power supply board and TX-HV board are different depending on the output power,
antenna resolution speed and TX output power. See page.4-64 to 4-71 for related
information. To connect with external monitors and VDR, the DVI IF board, RGB
buffer board and AD converter (GC-10 board) are available as option.
SPU
(03P9337)
POWER
(AC: 03P9339)
(DC: 03P9338)
TX-HV
(HV9017)
GC-10
(64P1106A)
TB
(03P9342)
HDG SENSOR
LOG
NAV DATA
ECDIS
PC
AIS
ALARM IN/OUT
Slave Display 1 (FULL-LOG) Slave Display 2 (SEM-LOG)
NET-100
(03P9332)
RGB
BUFFER
DVI IF
FIL
(AC: 03P9341)
(DC: 03P9352)
STD CONT
(RCU-014)
TRACKBALL
(RCU-015)
Ship’s Main
RF TX Data IF-VIDEO MIX
+24V TX HV MOTOR RF Rx Data
LAN
5/+12/-12V
MON MOTOR VLT
POWER FAIL
ANT ON
ANT SPEED
BP
+24/+12V MOTOR
24V-
HV
TX HV
R/G/B
H-SYNC
V-SYNC
RSV1-3 TD
NAV RD
ARPA TD
AD-10
OP1, 2 HD/BP/Trig/Video
OPHD/BP/Trig/Video
ANT 12V ON
GC LED/HOLD/UP/DOWN
AIS TD/RD
LOG RD
RF Tx/Rx Data
GYRO RD
TRK RD
EXT ALM ACK
EXT ALM1-4
KEY TX/RXD
RS232 TX/RX
-12/Vcc
GC 5V
LED HOLD UP DOWN AD-10
TRACK CONTROL
AD-10
+12/-12/-5V
Master
KEY TX/RD POWER SW SYSTEM FAIL +12V
Processor unit
(RPU-013)
SXGA
SXGA
I/O port
RFCp.c.b
(03P9346A)
Fig. 7.3.1 Block diagram of RPU-013

Furuno FAR-2117 Specifications

General

Brand	Furuno
Model	FAR-2117
Category	Marine Radar
Language	English