To Next Page

To Previous Page

Introduction ..................................................................................... 1

1. Calling up an operational menu...................................................................................1

2. Do not turn off the power immediately after changing the setting..............................1

3. Changing of IP address................................................................................................1

4. Display of HDG, SPD and POSN................................................................................1

5. Notes for setting .........................................................................................................1

6. Checking on NMEA data interface..............................................................................2

7. Loop Back test.............................................................................................................2

8. ERROR/ALM..............................................................................................................2

9. Program updating ........................................................................................................2

10. Connection of sub monitor........................................................................................2

11. LAN connection.........................................................................................................3

12. Connection with ECDIS ............................................................................................4

13. Compatibility of RPU-013.........................................................................................4

Chapter 1. Configuration ........................................................................ 1-1

1.1 Overview .................................................................................................................1-1

1.1.1 Samples ..........................................................................................................1-2

1. FAR-2127 and FAR-2827 ...........................................................................1-2

2. FAR-2137S and 2837S ...............................................................................1-2

3. FAR-2827W ................................................................................................1-3

4. FAR-2837SW .............................................................................................1-3

1.1.2 Inter-switch ....................................................................................................1-4

1.2 Configuration ...........................................................................................................1-5

1.2.1 System configuration table ............................................................................1-5

1.2.2 Processor unit: RPU-013 ...............................................................................1-8

1.2.3 Cable ..............................................................................................................1-9

1. Cable length for each unit ...........................................................................1-9

2. LAN cable ...................................................................................................1-9

3. Extending cables between Antenna unit and Processor unit ......................1-10

1.2.4 Antenna unit ..................................................................................................1-11

1. Applicable model: FAR-2117, 2127, 2817, 2827, 2117-BB and 2127-BB 1-11

2. Applicable model: FAR-2827W .................................................................1-12

3. Applicable model: FAR-2137S, 2837S and 2137S-BB ..............................1-13

4. Applicable model: FAR-2837SW ...............................................................1-15

1.3 Specifications ...........................................................................................................1-16

1.3.1 TR unit and Antenna Radiator .......................................................................1-16

1.3.2 Monitor unit ...................................................................................................1-18

1.3.3 Current power consumption ..........................................................................1-19

1.4 List of Functions ......................................................................................................1-20

Content

Furuno FAR-2117 Service Manual

Other manuals for Furuno FAR-2117