8. MAINTENANCE AND TROUBLESHOOTING
8-7
8.6 How to Replace the Fuse
The 10A fuse (for 12 VDC) or 5A fuse (for 24 VDC) in the power cable for the commu-
nication unit protects the system from overcurrent and reverse polarity. If the fuse
blows, find the cause before replacing it. If the fuse blows again after replacement,
contact your dealer for advice.
8.7 Error Messages
This section describes the more commonly seen error messages and the means to
restore normal operation. If normal operation cannot be restored, contact your dealer
for advice.
8.7.1 Equipment trouble messages
Messages in this category are prefixed with "TROUBLE".
WARNING
Use the proper fuse.
Use of a wrong fuse can result in fire or damage
the equipment.
12 VDC
Type: FGBO 125V 10A PBF
Code No.: 000-155-826-10
24 VDC
Type: FGBO-A 125V 5A PBF
Code No.: 000-155-853-10
Error message Meaning Action
ANT power voltage abnor-
mality.
Antenna power voltage is
out of ratings.
Have a licensed radio-
communications techni-
cian check the set.
Carrier power level. Carrier power level too high
or too low.
Have a licensed radio-
communications techni-
cian check the set.
EEPROM ERROR. EEPROM trouble. Contact a FURUNO agent
or dealer for advice.
Invalid MES ID. This equip-
ment is defected. Please
contact FURUNO.
MES ID is corrupted. Have a licensed radio-
communications techni-
cian check the set.
Synthesizer UNLOCK. Synthesizer unlock. Have a licensed radio-
communications techni-
cian check the set.
To Next Page
Loading...
Need help?
General
