4. FILE OPERATIONS
4-9
4.8 How to Decode an E-Mail Attachment
When you can't read an e-mail attachment because it has been coded by MIME (Mul-
tipurpose Internet Mail Extensions), you may decode it as below.
1. Save the MIME-coded file to the hard disk. (See section 5.2.5 for the procedure.)
This step is not necessary if [Auto Receive Message Save] is turned on in the [Au-
to Mode Setup] menu.
2. Press the F1 and 9 keys to select [MIME (Decode)].
3. Select the file to decode then press the Enter key.
4. [Yes] is selected; press the Enter key to decode the file.
5. To change the file name, press the BackSpace key to erase the file name, enter
a new file name then press the Enter key. After decoding the file the screen looks
something like the one shown below.
6. Long-press the Esc key to return to the standby display.
7. Press the F1 and 2 keys.
8. Select the file selected at step 5 then press the Enter key.
MIME Decode
Checking 'E0970715.001'
. . .
Decode 'ABC.ini'?
Decode
Yes No
File chosen
File attachment
MIME Decode
Checking 'E0970715.001'
. . .
Decode 'ABC.ini'?
Now decoding
. . .
Complete.
Decoded 1 file (s).
Press any key to escape.
To Next Page
Loading...
Need help?
General
