Garmin aera 760 Pilot’s Guide
190-02674-00 Rev. B
3
Overview
Overview Navigation Flight Planning Hazard Avoidance Additional Features Appendices Index
If you do not want to use the unit, but you would like to charge the battery, you can
put the unit into Charge Mode. Connect the unit to an external power supply. Press
and hold the
POWER Button. Instead of completely turning off, the unit now goes
into Charge Mode.
The unit will run cooler and may allow more current to be available for charging the
battery while in Charge Mode.
MOUNTING THE aera 760 IN THE AIRCRAFT
Refer to Appendix D 'Installation & Interfacing' for information on mounting the
aera 760 in the aircraft.
TURNING THE UNIT ON/OFF
NOTE: The unit will turn off automatically after five minutes if on battery
power and the Initialization Page is not acknowledged.
Press the
POWER Button to turn the unit on. Press and hold the
POWER
Button to turn the unit off.
The first time the unit is turned on, the receiver must collect satellite data and
establish its present location. To ensure proper initialization, the aera 760 is shipped
from the factory in Autolocate mode, which allows the receiver to “find itself” anywhere
in the world.
During initialization, current database information is displayed. Database
information includes valid operating dates, cycle number, and database type. When
this information has been reviewed for currency (to ensure that no databases have
expired), the pilot is prompted to continue.
Touching the Press To Accept Button acknowledges this information, and the
Main Menu is displayed.
To Next Page
Loading...
Need help?
General
