GE ASTAT XT QT 0008U Series User Manual

43 • Control Keypad
4.7.11 Comm. Parameters
42
– Page 8 – With the DeviceNet Optional PCB
Function &
Default
Range Unit Description
COMM. PROTOCOL
DeviceNet
Profibus/
Modbus/
DeviceNet
Sets ASTAT-XT’s communication protocol.
Operational when the optional communication PCB is
installed.
Baud Rate
Set Manually
Set the Baud Rate by changing the position of the
rotary switches on the optional PCB as shown on section
C.1.5 page 109.
Parity Check
AUTO (DeviceNet)
User can not change Parity Check value.
DeviceNet ID
Set Manually
Set the unit ID by changing the position of the rotary
switches on the optional PCB as shown on section
C.1.5
page 109.
S. Link Par. Set
Disabled
Enabled/
Disabled
Enables parameter modification via serial
communication
Ser. Link Control
Disabled
Enabled/
Disabled
Enables start, stop, reset etc. via serial communication
Store Settings
COMM. Parameters
Enabled/
Disabled
Same as Store Settings Main Settings on
page 28.
Note:
After changing communication
parameters and storing
them, control power must be switched OFF and ON to
load new communication parameters.

GE ASTAT XT QT 0008U Series Specifications

General

Brand	GE
Model	ASTAT XT QT 0008U Series
Category	Controller
Language	English