GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
56 Moisture Target Series 6 Hygrometer User’s Manual
3.6 Setting Other Information
To change other settings, from the Main
Menu select Settings... and press Enter .
The following screen appears.
3.6.1 Entering the Passcode
The Settings Menu is the only menu that requires a passcode. The passcode
is a four-digit number that enables only authorized users to enter setup data.
The MTS6 prompts you to enter the passcode when you enter the Settings
Menu. See page 79 for your default passcode.
3.6.2 Setting the Fault Alarm
To configure the fault alarm, from the
Settings Menu select Fault Alarm and press
Enter . The following screen appears.
Note: To access the Fault Alarm menu, the
User Passcode is required (see section 3.6.1
above).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter and the following screen
appears.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English