Chapter 4. Service and Maintenance
Moisture Target Series 6 Hygrometer User’s Manual 81
Chapter 4. Service and Maintenance
4.1 Introduction
The MTS 6 is designed to be maintenance and trouble free. However,
because of severe process conditions and other factors, minor problems may
occur from time to time. Some of the most common problems and
recommended maintenance procedures are discussed in this chapter. If you
cannot find the information you need in this chapter, please consult GE for
help.
CAUTION! Do not attempt to troubleshoot the MTS 6 beyond
the instructions in this chapter. If you do, you may damage
the unit and void the warranty.
This chapter covers the following topics:
• common problems
• replacing/recalibrating moisture probes
• cleaning the front panel
Proceed to the appropriate section to perform any of the above tasks.
4.2 Common Problems
If the MTS 6 measurements read too wet or too dry, or if they do not make
sense, there may be a problem with either the probe or a process component.
Use the descriptions of common problems in Table 3 on page 82 to
troubleshoot and solve such problems.
To Next Page
Need help?
General
