GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
Moisture Target Series 6 Hygrometer User’s Manual 67
3.6.7 Entering the M Series Probe Serial Number
Note: The following procedure applies only if an M Series probe is being
used. If a VeriDri probe is used, Probe SN is not accessible.
To update the probe serial number, from the
Settings Menu select Cal Data and press
Enter . The following screen appears.
Note: To access the Cal Data menu, the User
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter a screen similar to the
following appears.
To view and/or edit the probe serial number,
select Probe SN and press Enter . The
following screen appears.
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the changes have been made,
press Enter . The screen returns to the
Cal Data menu.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English