GE Moisture Target Series 6 User Manual

Chapter 3. Operation and Programming
Moisture Target Series 6 Hygrometer User’s Manual 73
3.6.10 Selecting the Probe Type
Note: Use the following procedure to select the probe type.
IMPORTANT: Changing the probe setting will default the output and alarm
settings to DPC. Also, the default fault trip point values will be
set along with the default output range values.
From the Settings Menu select Probes and
press Enter . The following screen
appears.
Note: To access the Probes menu, the User
Passcode is required (see section 3.6.1 on
page 56).
Use the left and right arrow keys to select
each digit to be changed and the up and
down arrow keys to increase or decrease its
value. Once the passcode has been entered,
press Enter and the following screen
appears.
Use the left or right arrow key to select the
correct probe type and press Enter . The
MTS6 reboots in 5 seconds.

GE Moisture Target Series 6 Specifications

General

Brand	GE
Model	Moisture Target Series 6
Category	Measuring Instruments
Language	English