GE HEALTHCAREDRAFT VOLUSON E8 / VOLUSON E6
D
IRECTION KTD102576, REVISION 7 DRAFT (AUGUST 23, 2012) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-65
Section 3-12
Network IP Address Configuration
NOTE: Following Information must be provided by customer or hospital engineer before you can start:
A Station name, AE Title, IP address and Port Number for the Voluson E8 / Voluson E6.
The IP addresses for the default gateway and other routers at the site for ROUTING INFORMATION.
Only if necessary (e.g. for Internet access).
1.) Press the UTILITIES
key on the control panel.
2.) In the “Utilities” menu touch SYSTEM SETUP
to invoke the setup desktop on the screen.
3.) On the left side of the screen select CONNECTIVITY
and then click the DEVICE SETUP tab.
4.) Click the NETWORK CONFIGURATION
button, read the message and confirm with YES.
5.) The “Internet Protocol (TCP/IP) Properties” dialog page appears.
To specify a DICOM Address, follow the instructions of described in the Basic User Manual of the
Voluson E8 / Voluson E6.
Figure 3-62 Network Configuration
Figure 3-63 Internet Protocol (TCP/IP)
click [Network Configuration] button, read
message and afterwards confirm with [Yes]
If fixed IP address is required,
you need to ask your network
administrator for the appropriate
settings.
Type in:
• IP address
• Subnet mask
• Default gateway
•DNS server
You can get IP and DNS
settings assigned
automatically,
if your network supports this
capability.
Note: This Example shows
fictional numbers.
To Next Page
Loading...
Need help?
General
