2 - Safety notes
10
€
Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing.
€
Disconnect electrical power before servicing and depressurize equipment after use and before servicing.
€
If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all inflammable or explosive material from the area.
€
The External Cleaning Device should not be used if essential parts of the equipment have been damaged, including
safety devices, high pressure hoses, etc.
Label explanation
The labels designate potential dangerous places on the machine. Anybody working with or being in close range of the
sprayer must respect these labels!
The labels should always be clean and readable! Worn or damaged labels must be replaced with new ones. Contact your
local dealer for new labels.
÷
Note that not all labels shown here will apply to your sprayer.
Chemical handling!
Carefully read the information about chemical
preparation before handling the machine.
Observe instructions and safety rules when
operating.
Service!
Carefully read operator’s instruction book
before handling the machine. Observe
instructions and safety rules when operating.
Service!
Shut off the engine and remove ignition key
before performing maintenance or repair.
Service!
Tighten to torque according to instruction
book.
Risk of death!
Do not attempt to enter tank.
Risk of burn!
Stay clear of hot surfaces.
Risk of injury!
Do not open or remove safety shields while
engine is running.
Risk of injury!
Flying objects, keep safe distance from
machine as long as the engine is running.
Risk of injury!
Keep sufficient distance away from electrical
power lines.
Risk of injury!
Keep hands away.
To Next Page
Loading...
Need help?
General
