3 - Description
19
Clean water tank
The water in this tank is for hand washing, cleaning of clogged nozzles
etc. Only fill this tank with clean water from the well.
Capacity: approximately 5 gal (20 liters).
±
WARNING! Although the clean water tank is only filled with clean
water, this water must NOT be used for drinking.
Rinsing tank
A rinsing tank is mounted to the rear of the sprayer. The tank is made of impact-proof and chemical resistant polyethylene.
Filling is done via the 2” Quick Coupler and valve placed in the working area. The rinsing tank level indicator is placed at the
platform.
Nominal content: approximately 120 gal (450 liters).
Filters
An EasyClean suction filter is fitted in the working zone.
A Cyclone pressure filter is fitted to the sprayers right side just in front of the optional hose reel, hidden behind the right front
cover. It has a built-in self-cleaning function.
In-line pressure filters can be fitted at each boom section as standard.
Nozzle filters are fitted at each nozzle (optional).
All filters should always be in use and their function checked regularly. Pay attention to the correct combination of filter and
mesh size (see “Spray Technique” book).
EasyClean filter
To ensure proper function of filter and its built-in valve the filter must be
opened at least 1 time per month. A label on the lid also designates this.
• To open filter then turn it counterclockwise and pull it up, like
shown on picture.
• Pull out the two locks (A) to remove filter element from the lid.
Beside the spray pressure gauge on the platform a EasyClean clogging
indicator is located:
Clogging indicator color Filter status
Green indicator. No cleaning necessary.
Yellow indicator. It is possible to finish an ongoing spraying job
and then clean filter afterwards.
Red indicator. Clean EasyClean filter immediately as filter is
clogged.
To Next Page
Loading...
Need help?
General
