2 - Safety notes
12
€
Rinse and wash equipment after use and before servicing.
€
Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing.
€
Disconnect electrical power before servicing and depressurize equipment after use and before servicing.
€
If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all inflammable or explosive material from the area.
€
The External Cleaning Device should not be used if important parts of the equipment have been damaged, including
safety devices, high pressure hoses, etc.
Label explanation
The labels are designating potential dangerous places on the machine. Anybody working with or being in close range of
the sprayer must respect these labels!
The labels should always be clean and readable! Worn or damaged labels must be replaced with new ones. Contact your
local dealer for new labels.
÷
Note that not all labels shown here will apply to your sprayer.
Tank under pressure!
Beware when moving lid.
Grapping area!
Manual handling of boom etc
Service!
Carefully read operators instruction book
before handling the machine. Observe
instructions and safety rules when operating.
Risk of squeeze!
Stay clear of raised unsecured loads.
Chemical handling!
Carefully read the informations about
chemical preparation before handling the
machine. Observe instructions and safety
rules when operating.
Risk of death!
Do not attempt to enter tank.
Risk of injury!
Keep sufficient distance away from electrical
power.
Not for drinking!
This water may not be used for drinking water.
To Next Page
Loading...
Need help?
General
