Hardi NAVIGATOR 4000 Original Instruction Book

33
4 - Sprayer setup
General info
Unloading the sprayer from the truck
For the unloading of the sprayer, you need a crane. When unloading
with a crane please observe the lifting points as shown in the picture,
and make sure that the straps or belts used for lifting are strong enough.
μ
ATTENTION! Only lift the sprayer when the tanks are empty!
Pulling the sprayer at the tie down hooks
For moving the sprayer or loading it to e.g. a truck it can be pulled in the
hooks at the rear-end (A) or a hook can be fastened into the hole in the
front end of the sprayer (B).
Before putting the sprayer into operation
Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal parts
in order to avoid chemicals and fertilizers discoloring the enamel.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the enamel clean for many years. This treatment should be carried out every time the protection film is washed off.

Hardi NAVIGATOR 4000 Specifications

General

Brand	Hardi
Model	NAVIGATOR 4000
Category	Paint Sprayer
Language	English