166
8 Data communications
This chapter briefly describes the data communication between the Analyzers and the
DMS Software.
8.1 Interaction
Application – Analyzer
Specially developed DMS Software or an OR
with an interface for the Analyzers is
necessary to provide full data management
for the Analyzers. Results of measurement
are transferred to the DMS Software or the
OR for storage and evaluation. Settings in an
Analyzer can be updated from the DMS
Software or an OR.
The Analyzer must be placed in a Docking
Station that is connencted to a PC or to an
Observation Reviewer (OR) to facilitate
communication with the DMS Software or
OR.
Remove the Analyzer if there is no
communication between the Analyzer and
the Docking Station and then re-dock the
Analyzer in the Docking Station.
Depending on the settings, one or several
Analyzers can be connected and
administered by the same PC or OR via the
Docking Stations (see 8.2 Docking station
setup).
To Next Page
Loading...
Need help?
General
