10 Zone LED Alarm Panel - Engineering Manual
10
Fitting the Remote Keypad
a. Separate the RKP base plate from the main assembly by slackening the retaining screw.
b. Cut away the required thin wall sections around the edges of the base plate for cable entry.
c. The base plate may be fitted directly to the wall using the screws and wall plugs supplied, if
these are not appropriate for the wall the use suitable alternative fixings.
d. Bring the cables into the base plate and wire to the terminal block on the base plate, see
diagram on the previous page.
e. Refit the RKP main assembly to the base plate by hooking it onto the top holding clips.
Check that the wiring does not foul the tamper switch/spring or the PCB support pillar.
Rescuer the screw in the bottom of the case.
2.5 - Security Zones
PIR and MS connection to the control panel block diagram.
2.6 - Fire Zone Circuit
Any zone may be programmed as a
fire zone. This will automatically
exclude the availability
of the zone from programs and normal
security applications.
MC
To Next Page
Loading...
Need help?
General