Hitron CODA-551x User Manual

Version 1.1, 09/2020. Copyright 2012 Hitron Technologies
17
Version 1.1, 09/2020. Copyright 2020 Hitron Technologies
17
Hitron CODA-551x User’s Guide
1.4 IP Address Setup
Before you log into the CODA-551x’s GUI, your computer’s IP address must be in the
same subnet as the CODA-551x. This allows your computer to communicate with the
CODA-551x.
NOTE: See When the CODA-551x is not in routing mode, the service provider
assigns an IP address to each computer connected to the CODA-551x
directly. The CODA-551x does not perform any routing operations, and traffic
flows between the computers and the service provider. on page 58 for
background information.
If your computer is configured to get an IP address automatically, or if you are not
sure, try to log in to the CODA-551x (see
GUI Overview on page 20).
If the login screen displays, your computer is already configured correctly.
If the login screen does not display, your computer is not configured correctly.
Follow the procedure in Manual IP Address Setup on page 18 and set your
computer to get an IP address automatically. Try to log in again. If you cannot
log in, follow the manual IP address setup procedure again, and set a specific IP
address as shown. Try to log in again.
Solid-White Online & all enabled-radios active (Steady-state),
Device in the Gateway Mode.
Solid-Cyan Device in the Bridge Mode or all Wi-Fi disabled but
device fully online.
Blue Blinking WPS Sync
Blue Solid (5 seconds) WPS Paired
Light-Blue Phone off hook (CODA-5519).
Cyan/White alternating Software upgrade in progress
Red Blinking DOCSIS Issue (e.g. ranging issue / no signal).
Red Slow Blink Provision Issue (e.g. authorized or failed to
download configuration file).
Solid-Red HW Failure
Table 3: LEDs

Hitron CODA-551x Specifications

General

Brand	Hitron
Model	CODA-551x
Category	Gateway
Language	English