Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 179
13. Place the wheel wrench over
the wheel nuts and loosen by
half a turn, but do not remove
the wheel nuts.
14. Position the jack beneath the
jack location closest to the
wheel being changed.
The locations are identified by
cut-outs in the underside of the
door sill.
15. Rotate the jack handle to raise
the head slightly.
16. Attach the jack handle to the
jack and attach the wheel
wrench to the jack handle.
17. Wind the jack up by hand until
it engages with the jacking
point.
Ensure the jack is not tilted and
the base is resting squarely on
the ground.
{
Warning
Failure to position the jack as
described could cause the vehicle
to slip off the jack.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
To Next Page
Loading...
Need help?
General
