Honda CRF450X 2010 User Manual

CRANKCASE/CRANKSHAFT /TRANSMISSION/BALANCER
BALANCER GEAR/BALANCER
REMOVAL
Remove the following :
- Rig ht crankcase cover (page 11-51
- l eft crankcase cover (page 12-4)
- Clutch (page ' ' -7)
- Starter clutch (page 11 -'9)
Insert the gear holder between the balan ce r drive
and driven gears.
TOOL:
Gsar holder , Ml .5
07724·0010200
or
07724·001A200
(U.S.A. only)
Rem ove the balancer shaft nut and washer us i ng
the special tools.
TOOL S:
lo ck nut wrench , 20 x 24 mm 07716·0020100
Extension bar 07716·0020500 or
commerciallyavail -
able equiva l ent
(U.S.A. on ly )
Remove the balancer
drive and driven gear s.
Turn the balancer shaft as shown and remo ve it.
INSPECTION
Check the balancer shah for wear, damage or exces-
sive scratches.
Check the balancer shah gear for wear or damage.
Check the balancer drive/d riven gear for wear or
damage.
INSTALLATION
Enf1lJge the Install the balancer shaft into the crankcase as
balancer shBft gear shown .
port/Otl WIth the oil
pump driven gear.
13-8
Install the balancer drive gear whi le aligning it s
wide cut-out in the splines with the punch mark on
the crankshaft.

Honda CRF450X 2010 Specifications

General

Brand	Honda
Model	CRF450X 2010
Category	Motorcycle
Language	English