Honda CRF450X 2010 User Manual

ELECTRIC STARTER
19-14
POWER INPUT liNE
Connect the starter relay sw itch 4P connector .
Shift the transmission into neutral.
Pull the clutch lever fully , and push the starter
switch.
Measure the voltage between the Yellow/ red wire
terminal (+) and ground H.
If the battery vo ltage appears only when the clutch
lever is pulled fully and starter switch is pushed, the
circuit is normal.
OPERATION CHECK
Remove the starter relay switch (page 19-14 ),
Connect a fully charged 12 V battery positive wire to
the relay switc h Yellow/red wire terminal and the
negative wire to the Green wire terminal.
There should be continuity between the cable termi -
nals when the battery is connected, and no t continu-
ity when the battery is disconnected.
REMOVAL/INSTALLA TION
Remove the left side cover (page 3-3).
Disconnect
the starter re lay switch 4P connecto r.
Pull out the starter re lay switch from the rear fender.
Remove the
bolts and disconnect the starter motor
and battery positive (+) cables.
Installation
is in the reverse order of removal.
•

Honda CRF450X 2010 Specifications

General

Brand	Honda
Model	CRF450X 2010
Category	Motorcycle
Language	English