Device Configuration and Commissioning 7
This function is available in normal mode during online parametrization only.
Requirement is that the calibration switch is open. Depending on the action
you want to execute, you need the user right Erase fiscal audit trail/fiscal
archives and/or the rights for the individual counters on parameter level.
Call:
<Stream 1/Stream 2>, tab End of commissioning
7.2.7 Sealing (if necessary)
It may be necessary for the device as well as sensor and signal lines to be
sealed by a metrology expert when it is used within the scope of legal metro-
logy. The conditions of the applicable authorization must be observed in this
case.
To Next Page
Loading...
Need help?
General
