6 Assembly Instructions
ATTENTION!
The integrated circuits of the process boards may be
damaged due to electrostatic discharges.
According to EN 61340-5-1, an ESD-protected workplace (ESD
pad and ESD wrist strap) must be used while working on a device
when changing the I/O board configuration.
ATTENTION!
Incorrect replacement parts and accessories are a safety
risk!
Incorrect or defective replacement parts and accessories
may detract from safety and lead to damage, malfunction, or
total device failure.
• Use only original replacement parts and accessories from the
manufacturer.
If required, please contact our support staff directly.
6.3.1 Insert a Process Board in a Free Board Slot
The method used for changing or removing process boards is similar.
► Ensure that all the required accessories are available:
• process board(s)
• suitable labelling plate(s)
• jumper(s)
To Next Page
Loading...
Need help?
General
