12 EDA51 User Guide
• See Charge the Battery Before Use on page 5 for approved charging methods.
Use of this battery in other devices could result in damage to the device or
battery.
• Avoid dropping the battery or computer. If you suspect that the battery or
computer is damaged, send it to Honeywell service center for inspection.
• Replace the battery only with another BAT-EDA50 model battery (Battery Part
Numbers on page 5). This battery has been tested in accordance with applicable
safety standards. Contact your Honeywell sales representative or distributor if
this battery is no longer available.
• Discarded batteries may create a safety hazard. Before disposal, cover the
battery contacts with electrical insulating tape.
• Do not modify the battery or attempt to insert foreign objects into it.
• Do not solder directly to the battery contacts.
• Do not drop the battery or apply mechanical shocks or pressure to it.
• Do not immerse batteries into, or expose them to, water or seawater.
• Do not incinerate, microwave, throw into a fire, or expose batteries to
temperatures above the maximum rating.
• Do not dissemble a battery or try to open or penetrate its housing.
Enable Airplane Mode
If you do not need to connect to any WWAN networks, you can enable Airplane
mode to turn Off the radios and save battery power.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Network & Internet.
3. Tap the toggle button next to Airplane mode. An airplane icon appears in
the status bar to indicate Airplane mode is turned On.
Power on the Computer
After you have fully charged and installed a battery, power on the computer for the
first time:
• Press and hold the Power button for approximately 3 seconds, and then release
the button.
To Next Page
Loading...
Need help?
General