Lockout
Command
To lockout the front panel controls use the SYSTem command
LOCKout.
When this function is on, all controls (except the power switch) are
entirely locked out. Local control can only be restored by sending the
command
:LOCKout
OFF. For more information on this command see
the chapter “System Commands” in this manual.
r
fi
Note
@
Cycling the power will also restore local control, but this will also reset
certain RS-232C states.
HP
1650B/HP
1651B
Programming Over RS-232C
Programming Reference
3-7
To Next Page
Loading...
Need help?
General
