To Next Page

To Previous Page

System Commands

Introduction

System commands control the basic operation of the instrument including

formatting query responses and enabling reading and writing to the

advisory line of the instrument’s display. They can be called at anytime.

The HP 1650B/51B System commands are:

ARMBnc

DATA

DSP (display)

ERRor

HEADer

KEY

LER (Local Event Register)

LOCKout

LONGform

MESE

MESR

SETup

In addition to the system commands, there is are three run control

commands and a preprocessor power supply condition query. These

commands are:

PPOWer

RMODe

STARt

l STOP

The run control commands can be called at anytime and also control the

basic operation of the logic analyzer. These commands are at the same

level in the command tree as SYSTem; therefore they are not preceded by

the

:SYSTem

header.

1650B/HP

165lB

System Commands

Programming Reference

6-l

HP 1650B User Manual

Questions and Answers: