318
[Switch] user-interface vty 0 15
[Switch-ui-vty0-15] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Switch-ui-vty0-15] protocol inbound ssh
[Switch-ui-vty0-15] quit
# Create local user client001, and set the user command privilege level to 3
[Switch] local-user client001
[Switch-luser-client001] password simple aabbcc
[Switch-luser-client001] service-type ssh
[Switch-luser-client001] authorization-attribute level 3
[Switch-luser-client001] quit
# Specify the service type for user client001 as stelnet, and the authentication method as password.
This step is optional.
[Switch] ssh user client001 service-type stelnet authentication-type password
2. Establish a connection between the SSH client and the SSH server:
The switch supports a variety of SSH client software, such as PuTTY, and OpenSSH. The following
example uses PuTTY Version 0.58.
To establish a connection to the SSH server:
a. Launch PuTTY.exe to enter the interface as shown in Figure 91.
b. In the H
ost Name (or IP address) text box, enter the IP address of the server 192.168.1.40.
Figure 91 Specifying the host name (or IP address)
To Next Page
Loading...
Need help?
General