1. SAS connector
3. Power on/off switch
2. Power con
nector
Figure29Connectingthecablestothetapedrive
WARNING!
The supplied power cord is HP appro ved for your specific geographic region. Use of a
non-HP approved power cord may result in: 1) not meeting individual country specific
safety requirements; 2) insufficient conductor ampacity that could result in overheating
with potential personal injury and/or property damage; and 3) an unapproved power
cord could fracture resulting in the internal contacts b eing exposed, which potentially
could su
bject the user to a shock hazard. HP disclaims all liability in the event a non-HP
approved power cord is used.
Reboot the server
Switch on the tape drive and power up the server. The power on/off switch is on the front panel.
Watch the boot scre en c arefully after installation. If there are any error or unexpected messages go back
and check the SAS cabling carefully.
If this does not resolve the p roblem, refer to “Troubleshooting” on page 73 for further guidelines.
Ultrium half-height SAS Tape Drives
51
To Next Page
Loading...
Need help?
General