EasyManuals Logo
Home>HP>Switch>FlexFabric 5700 series

HP FlexFabric 5700 series User Manual

HP FlexFabric 5700 series
460 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
179
Ste
Command
Remarks
4. Set the port security mode.
port-security port-mode
{ autolearn | mac-authentication |
mac-else-userlogin-secure |
mac-else-userlogin-secure-ext |
secure | userlogin |
userlogin-secure |
userlogin-secure-ext |
userlogin-secure-or-mac |
userlogin-secure-or-mac-ext |
userlogin-withoui }
By default, a port operates in
noRestrictions mode.
After enabling port security, you
can change the port security mode
of a port only when the port is
operating in noRestrictions (the
default) mode. To change the port
security mode for a port in any
other mode, first use the undo
port-security port-mode command
to restore the default port security
mode.
Configuring port security features
Configuring NTK
The NTK feature checks the destination MAC addresses in outbound frames to make sure frames are
forwarded only to authenticated devices.
The NTK feature supports the following modes:
• ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.
• ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated
destination MAC addresses.
• ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames with
authenticated destination MAC addresses.
The NTK feature drops any unicast frame with an unknown destination MAC address. Not all port
security modes support triggering the NTK feature. For more information, see Table 14.
T
o configure the NTK feature:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Configure the NTK feature.
port-security ntk-mode
{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }
By default, NTK is disabled on a
port and all frames are allowed to
be sent.
Configuring intrusion protection
Intrusion protection enables a device to take one of the following actions in response to illegal frames:
• blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC address list and
discards the frames. All subsequent frames sourced from a blocked MAC address are dropped. A

Table of Contents

Other manuals for HP FlexFabric 5700 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexFabric 5700 series and is the answer not in the manual?

HP FlexFabric 5700 series Specifications

General IconGeneral
BrandHP
ModelFlexFabric 5700 series
CategorySwitch
LanguageEnglish

Related product manuals