HP FlexFabric 5700 series User Manual

180
blocked MAC address is restored to normal state after being blocked for 3 minutes. The interval is
fixed and cannot be changed.
• disableport—Disables the port until you bring it up manually.
• disableport-temporarily—Disables the port for a period of time. The period can be configured with
the port-security timer disableport command.
To configure the intrusion protection feature:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Configure the intrusion
protection feature.
port-security intrusion-mode
{ blockmac | disableport |
disableport-temporarily }
By default, intrusion protection is
disabled.
4. Return to system view.
quit N/A
5. (Optional.) Set the silence
timeout period during which a
port remains disabled.
port-security timer disableport
time-value
By default, the port silence timeout
is 20 seconds.
NOTE:
On a port operating in either macAddressElseUserLoginSecure mode or
macAddressElseUserLoginSecureExt mode, intrusion protection is triggered only after both MAC
authentication and 802.1X authentication fail for the same frame.
Configuring secure MAC addresses
Secure MAC addresses are configured or learned in autoLearn mode. If the secure MAC addresses are
saved, they can survive a device reboot. You can bind a secure MAC address only to one port in a
VLAN.
When the maximum number of secure MAC address entries is reached, the port changes to secure mode.
In secure mode, the port cannot add or learn any more secure MAC addresses. The port allows only
frames sourced from secure MAC addresses or MAC addresses configured by using the mac-address
dynamic or mac-address static command to pass through.
Secure MAC addresses include static, sticky, and dynamic secure MAC addresses.

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English