350
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
The following interface types are
supported:
• Layer 2 Ethernet interface.
• VLAN interface.
3. Enable the IPv6SG feature.
ipv6 verify source { ip-address |
ip-address mac-address |
mac-address }
By default, the IPv6SG feature is
disabled on an interface.
If you configure this command on
an interface multiple times, the
most recent configuration takes
effect.
Configuring a static IPv6SG binding
You can configure global static and interface-specific static IPv6SG bindings.
Global static bindings take effect on all interfaces.
Interface-specific static bindings take priority over global static bindings. An interface first uses the static
bindings on the interface to match packets. If no match is found, the interface uses the global bindings.
Configuring a global static IPv6SG binding
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure a global
static IPv6SG binding.
ipv6 source binding ip-address ipv6-address
mac-address mac-address
No global static IPv6SG
binding exists.
Configuring a static IPv6SG binding on an interface
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
The following interface types are supported:
• Layer 2 Ethernet interface.
• VLAN interface.
3. Configure a static
IPv6SG binding.
ipv6 source binding { ip-address
ipv6-address | ip-address
ipv6-address mac-address
mac-address | mac-address
mac-address } [ vlan vlan-id ]
By default, no static IPv6SG binding is
configured on an interface.
The vlan vlan-id option is supported only in
Layer 2 Ethernet interface view.
You can configure the same static IPv6SG
binding on different interfaces.
Displaying and maintaining IPSG
Execute display commands in any view and reset commands in user view.