HP FlexFabric 5700 series User Manual

396
Ste
p
Command Remarks
2. Create a user profile and
enter user profile view.
user-profile profile-name
You can use the command to enter
the view of an existing user profile.
Configuring parameters for a user profile
Configurations in user profile view take effect only after the device applies the user profile to the user.
Configuring QoS parameters for traffic management
To configure QoS parameters:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter user profile view.
user-profile profile-name N/A
3. Apply a QoS policy
qos apply policy policy-name
{ inbound | outbound }
The QoS policy must already exist.
For information about QoS policy
configuration, see ACL and QoS
Configuration Guide.
For information about the
commands, see ACL and QoS
Command Reference.
Displaying and maintaining user profiles
Execute display commands in any view.
Task Command
Display configuration and online user information
for the specified user profile or all user profiles.
display user-profile [ name profile-name ] [ slot
slot-number ]
User profile configuration examples
Local 802.1X authentication/authorization with QoS policy
configuration example
Network requirements
As shown in Figure 120, the access switch performs local 802.1X authentication and authorization for
User A, User B, and User C.
Configure user profiles for the users and apply a QoS policy to each user to implement the following
functions:

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English