HP FlexFabric 5700 series User Manual

84
This feature provides the multicast trigger and unicast trigger (see 802.1X authentication initiation in
"802.1X overview")
.
Configuration guidelines
When you configure the authentication trigger feature, follow these guidelines:
• Enable the multicast trigger on a port when the clients attached to the port cannot send EAPOL-Start
packets to initiate 802.1X authentication.
• Enable the unicast trigger on a port if only a few 802.1X clients are attached to the port and these
clients cannot initiate authentication.
• To avoid duplicate authentication packets, do not enable both triggers on a port.
Configuration procedure
To configure the authentication trigger feature on a port:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. (Optional.) Set the username
request timeout timer.
dot1x timer tx-period
tx-period-value
The default is 30 seconds.
3. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
4. Enable an authentication
trigger.
dot1x { multicast-trigger |
unicast-trigger }
By default, the multicast trigger is
enabled, and the unicast trigger is
disabled.
Specifying a mandatory authentication domain on
a port
You can place all 802.1X users in a mandatory authentication domain for authentication, authorization,
and accounting on a port. No user can use an account in any other domain to access the network
through the port. The implementation of a mandatory authentication domain enhances the flexibility of
802.1X access control deployment.
To specify a mandatory authentication domain for a port:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Specify a mandatory 802.1X
authentication domain on the
port.
dot1x mandatory-domain
domain-name
By default, no mandatory 802.1X
authentication domain is specified.

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English