Installation Summary
This chapter describes the installation procedures for the router
module. The following is a summary of those procedures:
1. Check the Version of the SNMP Module. The HP AdvanceStack
10Base-T Hub in which the HP Router 210 Module is to be installed
must also have an HP J2603B Ethernet SNMP Module installed. (The
router module will be mounted on the SNMP module.) This SNMP
module must be the HP J2603B version, not the HP J2603A version. If
an SNMP module is already installed but you are not sure which
version it is, you can determine the version using the procedure
beginning on page 1-5.
2. Prepare the Network. Create or update the network plan and the
network map (for details, refer to page 1-8). Verify that the network
equipment and links (in particular, the WAN-link-terminating
equipment) are operational. (Your WAN-link service provider can
verify that the WAN link is operating correctly.) If the LAN links are
not already connected to the hub, connect them now (refer to the
hub’s installation guide).
3. Install the Router Module.
a. Disconnect the hub from the power source, then remove the
cover plate from the hub’s Expansion Slot.
b. Connect a grounding wrist strap between your wrist and the hub.
c. Remove the module from its packaging, and place it on a noncon-
ducting antistatic surface.
d. Remove the insulating paper between the battery and the battery
clip.
e. Remove the SNMP module from the Expansion Slot (if already
installed).
Installation
Installation Summary
1-2
To Next Page
Loading...
Need help?
General
