2. Set the Date and Time.
The current date and time appear at the top of the router module’s
console interface screens. The date and time is recorded with entries in
the event log (see page 2-11) and the crash history (which is displayed
by the NCL Crash command).
When the router module is first powered on after being installed in the
hub, it starts with a default date and time. The date and time are main-
tained in the router module’s battery-backed RAM. To set the current
date and time, use the NCL Time command as described below.
The date and time in the router module is used for other routers in the
network if the Time Protocol’s Mode parameter for DoD Internet Router
in the configuration is set to “Server only” or to “Server and client”. (For
more information about this parameter, refer to the Operator’s
Reference.)
To set the date and time:
At the NCL prompt, enter the Time command with the date and time as
follows:
time mm/dd/yy hh:mm:ss [Enter]
where:
mm = month hh = hour
dd = day mm = minute
yy = year ss = second
For details about the NCL Time command, refer to the Operator’s
Reference.
Installation
2. Set the Date and Time.
2-8
To Next Page
Loading...
Need help?
General
